Rompak

[Tony Brewer]

Photos (1-2 of 4)

Rompak case (end view)

rompak1.jpg (151.53 KiB) Viewed 7551 times

Rompak case (connector view)

rompak2.jpg (154.31 KiB) Viewed 7551 times

[Tony Brewer]

Photos (3-4 of 4)

Rompak PCB (component side)

rompak3.jpg (200.84 KiB) Viewed 7549 times

Rompak PCB (solder side)

rompak4.jpg (159.55 KiB) Viewed 7549 times

[Tony Brewer]

The Rompak is a very simple device, consisting of an EPROM, a 47 nF decoupling capacitor and a half length 30-way edge connector.

/GROM from the bus is connected to /CE and /OE of the EPROM, with A0-A12 and D0-D7 connected as one would expect.

The masking tape is not for insulation, but to wedge the PCB in one slot inside the plastic case as it is too short to reach the other slot.

The EPROM in the Rompak shown above contains the Node Ring software, which I spent a lot of time on at Witney.

My Speculator fitted inside the same Rompak case - just!

[Dave]

Hi Tony,

thanks a lot! - I will "pinch" a copy of your good photos for the site,

regards
Dave

[1024MAK]

I will "pinch" a copy of your good photos for the site,

You know Dave, if you keep going around "pinching" people, one day you may well get you yourself in trouble

Mark

[Dave]

I'll keep taking my chances!

Until I get a slap, it's good fun

[1024MAK]

BTW Tony, having been distracted by a Dave post, I forgot to say: thank you for posting these great photos

Mark