The MTX case profile drawings

About original Memotech hardware.
protek
Posts: 44
Joined: 02 Aug 2015 08:57
Location: Oulu, Finland

Re: The MTX case profile drawings

Post by protek »

Image

Something like this. Like a cradle.
protek
Posts: 44
Joined: 02 Aug 2015 08:57
Location: Oulu, Finland

Re: The MTX case profile drawings

Post by protek »

Image

I had some spare time, so thought I’d do some modifications to my Memotech expansion casing. Basically, I merged the side plate that has the opening for the expansion port with the bottom profile. Now it can be screwed into the Memotech, then it’s a matter of adding the top, the back plate and the side plate.
User avatar
Dave
Posts: 814
Joined: 11 Aug 2012 18:16
Contact:

Re: The MTX case profile drawings

Post by Dave »

That looks good!

When you say “merged”, does that mean that the part that you showed is printed in a single piece?

Regards
Dave
protek
Posts: 44
Joined: 02 Aug 2015 08:57
Location: Oulu, Finland

Re: The MTX case profile drawings

Post by protek »

Yeah, it’s now a single piece. The idea is to use countersunk screws to attach it to the main case, so that they sit flush to the back plate.

I may add some structural supports between the bottom profile and side plate to make it more rigid. Also, I might design on a supporting cradle for the expansion cards, like the one in the hand-drawn picture.
User avatar
Dave
Posts: 814
Joined: 11 Aug 2012 18:16
Contact:

Re: The MTX case profile drawings

Post by Dave »

That’s a good idea, I did think that the edge where the two parts join may be rather weak.

(The hand drawn sketch doesn’t seem to be displayed properly, at least, not on my iPad)

Regards
Dave
protek
Posts: 44
Joined: 02 Aug 2015 08:57
Location: Oulu, Finland

Re: The MTX case profile drawings

Post by protek »

Well, it’s a pretty crappy doodle anyway. :lol:

I’ll apply the supports. If you want to try to print it I can send you the file.

I’ve changed from 123D Design to Fusion 360. Here’s a case that I designed for the Oric Erebus expansion:

Image
User avatar
Dave
Posts: 814
Joined: 11 Aug 2012 18:16
Contact:

Re: The MTX case profile drawings

Post by Dave »

Thanks a lot, when you finalise the design, I will try to print it. (My 3D printer is packed away at the moment though)

Regards
Dave
Post Reply