Page 1 of 1
Rompak
Posted: 10 Jan 2014 22:09
by Tony Brewer
Photos (1-2 of 4)
- Rompak case (end view)
- rompak1.jpg (151.53 KiB) Viewed 13071 times
- Rompak case (connector view)
- rompak2.jpg (154.31 KiB) Viewed 13071 times
Re: Rompak
Posted: 10 Jan 2014 22:11
by Tony Brewer
Photos (3-4 of 4)
- Rompak PCB (component side)
- rompak3.jpg (200.84 KiB) Viewed 13069 times
- Rompak PCB (solder side)
- rompak4.jpg (159.55 KiB) Viewed 13069 times
Re: Rompak
Posted: 10 Jan 2014 22:15
by Tony Brewer
The Rompak is a very simple device, consisting of an EPROM, a 47 nF decoupling capacitor and a half length 30-way edge connector.
/GROM from the bus is connected to /CE and /OE of the EPROM, with A0-A12 and D0-D7 connected as one would expect.
The masking tape is not for insulation, but to wedge the PCB in one slot inside the plastic case as it is too short to reach the other slot.
The EPROM in the Rompak shown above contains the Node Ring software, which I spent a lot of time on at Witney.
My Speculator fitted inside the same Rompak case - just!
Re: Rompak
Posted: 10 Jan 2014 22:40
by Dave
Hi Tony,
thanks a lot! - I will "pinch" a copy of your good photos for the site,
regards
Dave
Re: Rompak
Posted: 11 Jan 2014 00:13
by 1024MAK
Dave wrote:I will "pinch" a copy of your good photos for the site,
You know Dave, if you keep going around "pinching" people, one day you may well get you yourself in trouble
Mark
Re: Rompak
Posted: 11 Jan 2014 00:55
by Dave
I'll keep taking my chances!
Until I get a slap, it's good fun
Re: Rompak
Posted: 18 Jan 2014 13:07
by 1024MAK
BTW Tony, having been distracted by a
Dave post, I forgot to say: thank you for posting these great photos
Mark