MFX mass-storage add-on - Original Thread

[Martin A]

That’s (hopefully) good, as my finger is not quite long enough to get to Dave’s (new) location to poke him…

Mark

You might not need to poke him now, a little bird tells me the MFX has been finished and shipped.

[1024MAK]

You might not need to poke him now, a little bird tells me the MFX has been finished and shipped.

Yes, it arrived yesterday. I’m still recovering from the extensive fight against the super strong brown sticky tape. My box cutter knife blade is apparently too blunt to cut through this stuff…

Mark

[Dave]

Yes, it arrived yesterday. I’m still recovering from the extensive fight against the super strong brown sticky tape. My box cutter knife blade is apparently too blunt to cut through this stuff…

Mark

Mmm, another observation on my packing technique - I may need to revisit it

[1024MAK]

Mmm, another observation on my packing technique - I may need to revisit it

Well, the good point is that apart from my knife blade, nothing was damaged

And to be fair, the blade was already well worn…

Although putting the label on the bottom of the box, which I did not realise until after I cut it open definitely slowed me down

Mark

[Dave]

Although putting the label on the bottom of the box, which I did not realise until after I cut it open definitely slowed me down

Mark

Those Royal Mail jokers must have swapped it over - it WAS on the top when it left here

[Martin A]

Mmm, another observation on my packing technique - I may need to revisit it

Well, the good point is that apart from my knife blade, nothing was damaged

And to be fair, the blade was already well worn…

Although putting the label on the bottom of the box, which I did not realise until after I cut it open definitely slowed me down

Mark

Your lucky it didn't come from me, I ran out of parcel tape. The pack of three that went back to Dave, was finished off with duct tape.

[Dave]

Totally sexy 20220919_171004.jpg

https://mtxworld.dk/memorum/viewtopic.p ... &start=108

Agree

So much so, that I've "stolen" a copy of the photo for the website - hope that's OK?

http://primrosebank.net/computers/mtx/p ... fx/mfx.htm

regards
Dave

[gunrock]

That's totally fine with me, Dave.

It's an honour, TBH!