Use of Assembler in MTX Basic.
Posted: 15 Feb 2021 10:23
Hi there.
I think it have been mentioned before, but when using Assembler in Basic, and you add or remove basic lines before the Assembler routines, it seems like the Basic dont "re-assemble". What is the best way to do this. To get it work yesterday I had to go into each of my assembly lines and do a list. It seems to work, but its a bit hard to do each time. Is there a better way. I assume actually its best to put a goto in the first basic line to jump around the assemble code and then call the assembly from a gosub routine?
I think it have been mentioned before, but when using Assembler in Basic, and you add or remove basic lines before the Assembler routines, it seems like the Basic dont "re-assemble". What is the best way to do this. To get it work yesterday I had to go into each of my assembly lines and do a list. It seems to work, but its a bit hard to do each time. Is there a better way. I assume actually its best to put a goto in the first basic line to jump around the assemble code and then call the assembly from a gosub routine?