MFX and soldered in RAM expansions

Posts related to the MFX Interface
Post questions about MFX and raise any issues or problems here
Post Reply
User avatar
Dave
Posts: 1327
Joined: 11 Aug 2012 18:16
Contact:
Contact Dave

MFX and soldered in RAM expansions

Post by Dave »

Soldered in Memotech memory boards don’t need to be a barrier to MFX!

Memotech frequently made MTX512s out of MTX500 computer boards by adding a RAM expansion card inside the case. Some were push fit edge connectors, in other cases, Memotech soldered the RAM board in place. This makes it difficult to install alternative expansion boards such as MFX.

However, it doesn’t need to be a show stopper! The latest MFX customer unsoldered the memory expansion without too much difficulty and was able to install MFX.

Another satisfied customer :D
Attachments
JR_edge_red2.png
JR_edge_red2.png (904.47 KiB) Viewed 21202 times
Top
User avatar
1024MAK
Posts: 785
Joined: 24 Dec 2012 03:01
Location: Looking forward to summer, in Somerset, UK

Re: MFX and soldered in RAM expansions

Post by 1024MAK »

What da yah mean? An angle grinder or jigsaw can quickly separate those RAM boards from the main board ;) :lol:

And you appear not to have posted the "after" photo :twisted:

Mark
:!: Standby alert :!:
“There are four lights!”
Step up to red alert. Sir, are you absolutely sure? It does mean changing the bulb :!:
Autumn is here. Bye bye summer 2024...

Not as many MTXs as Dave! :lol:
Top
User avatar
Dave
Posts: 1327
Joined: 11 Aug 2012 18:16
Contact:
Contact Dave

Re: MFX and soldered in RAM expansions

Post by Dave »

1024MAK wrote: ↑29 Aug 2024 20:44 What da yah mean? An angle grinder or jigsaw can quickly separate those RAM boards from the main board ;) :lol:

And you appear not to have posted the "after" photo :twisted:

Mark
Ha-ha, that may have been the tools that Jason used :D

Unfortunately, I don’t have an after photo - Jason . . .?
Top
Post Reply

Return to “MFX”